Yokogawa Button Operated MV2000 - Manual (Page 9)

CF Card Handling Precautions
• The CF card is delicate and should be handled with caution.
• Write operations to the CF card may fail if it is operated in a high-temperature or low-temperature environment.
If you are operating in a low temperature environment (about 10 ° C or less), wait for the MV to warm up (30
minutes or more) before using it. If you are operating in a high temperature environment (about 40 ° C), we
recommend that you insert the CF card into the drive when saving data, and remove it after the data has been
saved.
• Remove the CF card from the drive when switching the MV ON/OFF.
• Touching the compact flash section when static electricity is built up on the human body can lead to erroneous
operation.
CAUTION
• Do not remove the CF card while the access indicator is illuminated. This can damage the data.
• Do not use the CF card in a place subject to vibrations or shock. The CF card or drive may malfunction.
Protection of Environment
Control of Pollution Caused by the Product
For details, see Control of Pollution Caused by the Product (IM MV1000-91C).
Proper Disposal of This Product
This is an explanation of how to dispose of this product based on Waste Electrical and Electronic Equipment
(WEEE), Directive 2002/96/EC. This directive is only valid in the EU.
• Marking
This product complies with the WEEE Directive (2002/96/EC) marking requirement.
The label (see below) indicates that you must not discard this electrical/electronic product in domestic
household waste.
• Product Category
With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a “Monitoring
and Control instrumentation” product.
Do not dispose in domestic household waste.
To return unwanted products, contact your local Yokogawa Europe B. V. office.
Recycle Mark
The Ni-MH battery that is used by the MV1000 is recyclable. The following recycle mark is used on the battery to
indicate that it is recyclable.
9
IM MV1000-02E