3 causes of abnormal measured value, 4 other conditions – Yokogawa SC72 Personal Handheld Conductivity Meter User Manual
Page 55
IM 12D03D02-01E
6-4
6. Troubleshooting
6.3 Causes of Abnormal Measured Value
If error messages do not occur, but measured values seem incorrect, check the following:
* Are cell constants and temperature coefficients correctly set?
* Is the sensor properly connected to the meter?
* Are bubbles attached to the electrode portion?
* Is the sensor damaged or dirty?
6.4 Other conditions
• An alarm sounds
The alarm clock is set (see Sec. 4.3 (9) and change setting as required).
• To Enable / Disable Key-Press Audible Feedback (buzzer)
Refer to Sec. 4.3 (11) to change setting as required.
See also other documents in the category Yokogawa Sensors:
- EJA120A (79 pages)
- EJA130A (2 pages)
- EJA130A (4 pages)
- EJA120A (31 pages)
- EJA130A (47 pages)
- EJA120A (40 pages)
- EJA438 (5 pages)
- EJA120A (6 pages)
- EJA115 (85 pages)
- EJA120A (47 pages)
- EJA210A (70 pages)
- EJA130A (4 pages)
- EJA430A (78 pages)
- EJA210E (89 pages)
- EJA210E (170 pages)
- EJX120A (4 pages)
- EJA210E (9 pages)
- EJX115A (55 pages)
- EJA210E (41 pages)
- EJA210E (96 pages)
- EJA210E (52 pages)
- EJX910A (9 pages)
- EJX910A (103 pages)
- FlowNavigator Software (163 pages)
- EJX910A (55 pages)
- EJX910A (175 pages)
- EJX910A (83 pages)
- EJA530A (67 pages)
- EJA120A (83 pages)
- EJX530A (52 pages)
- EJA110E (4 pages)
- EJA110E (85 pages)
- EJX120A (85 pages)
- EJA118 (76 pages)
- EJX118A (64 pages)
- EJA438 (72 pages)
- EJA430E (85 pages)
- EJX430A (76 pages)
- EJA430E (7 pages)
- EJX430A (6 pages)
- EJX430A (40 pages)
- EJA430E (96 pages)
- EJA430E (41 pages)
- EJX438A (10 pages)
- ADMAG AXR (194 pages)