Watlow Series 965 - Manual (Page 5)

Install and Wire, Chapter 2 5
WATLOW Series 965 User's Manual
Installation Chapter 2
Install and Wire the Series 965
Figure 2 -
Series 965
Multiple Panel
Cutout Dimensions
Installation Procedure
Follow this procedure to mount the Watlow Series 965 temperature control:
1. Make a panel cutout per the dimensions in Figure 2.
2. Remove the 965 chassis from its case. Holding each side of the bezel,
press in firmly on the side grips until the tabs release. Pull the chassis out
of the case and set aside for later installation.
3. Make sure the rounded side of the external case gasket is facing the panel
surface. Check to see that the gasket is not twisted, and is seated within
the case bezel flush with the panel. Place the case in the cutout you just
made. Make sure the gasket is between the panel cutout and the case
bezel. See Figure 4A.
NOTE:
Measurements
between panel
cutouts are the
minimum
recommended.
Figure 3 -
Series 965
Dimensions
2.1"
(53 mm)
Panel Cutout
Your Panel
Thickness
0.06" to 0.38"
(1.5 to 9.7 mm)
1.77" to 1.79"
(44.96mm to 45.47mm)
1.77" to 1.79"
(44.96mm
to 45.47mm)
0.38"
(9.65mm)
Minimum
0.85"
(20mm)
0.40"
(10mm)
1.21"
(31mm)
4.1"
(104mm)
4.7"
(119mm)
1.76"
(45mm)
NOTE: For rapid
mounting, use
Greenlee punch
#60020 and die
#60021, or hand
hydraulic unit, Kit
#7306. All available
from Grainger.