Watlow EZ-ZONE PM Express - Manual (Page 26)

EZ-ZONE PM Express (PID) • 26 • Setup Menu
Setup Menu
Display Parameter Name Description
[`A;LA]
[ A.LA]
Alarm Latching
Turn alarm latching on or off. A latched alarm
has to be turned off by the user.
Appears if: When alarm type is set to process
or deviation alarm
[`A;bL]
[ A.bL]
Alarm Blocking
Select when an alarm will be blocked. After
startup and/or after the set point changes, the
alarm will be blocked until the process value
enters the normal range.
Appears if: When alarm type is set to process
or deviation alarm
[`A;si]
[ A.Si]
Alarm Silencing
Turn alarm silencing on to allow the user
to disable the output tied (configured) to
this alarm
Appears if: When alarm type is set to process
or deviation alarm
[A;dSP]
[A.dSP]
Alarm Display
Display an alarm message when an
alarm is active.
Appears if: When alarm type is set to process
or deviation alarm
[``rP]
[ rP]
Ramp Action
Select when the controller's set point will
ramp to the defined end set point.
Appears if: Always
[`r;rt]
[ r.rt]
Ramp Rate
Set the rate for the set point ramp. Set the
time units for the rate with the Ramp Scale
parameter.
Appears if: Ramp Action is set to Startup, Set
Point or Both.
[`s;lo]
[ S.Lo]
Scale Low Output 1
Set the scale low for process output in electri-
cal units. This value; in volts or mil liamps, will
correspond to 0% PID power output.
Appears if: Output 1 is a Process set to heat
or cool
‰
[`loC]
Lockout Menu
[`SEn]
Sensor Type
[`Lin]
Linearization
[``t;C]
Thermistor Curve
[``r;r]
Resistance Range
[`deC]
Decimal
[`C_F]
Display Units
[`r;lo]
Range Low
[`r;hi]
Range High
[`fn1]
Function Output 1
[`o;ty]
Output Type
[`fn2]
Function Output 2
[`h;ag]
Heat Algorithm
[`h;sC]
Hysteresis (Heat & Cool)
[`C;Ag]
Cool Algorithm
[`A;ty]
Alarm Type
[`A;hy]
Alarm Hysteresis
[`A;lg]
Alarm Logic
[`A;lA]
Alarm Latching
[`A;bl]
Alarm Blocking
[`A;si]
Alarm Silencing
[A;dsp]
Alarm Display
[``rp]
Ramp Action
[`r;rt]
Ramp Rate
[`s;lo]
Scale Low
[`s;hi]
Scale High
[o;hi1]
Power Scale High Output 1
[o;hi2]
Power Scale High Output 2
[`Ad;s]
Zone Address
Setup Menu
To enter the Setup Menu push and hold the
up and down arrow keys for approximately
3 seconds. Once there, push the green
advance key to scroll through to the prompt
of choice and then use the up and down
arrow keys to change the range. At any
point within the Setup menu to return to the
default display push the Infinity ˆ key.