Proface APL3000B - Node Box PC - Manual (Page 78)

Chapter 3 Installation and Wiring
3-21
Wiring
When connecting the power cord, use the following items when performing wiring. (Items are made by
Phoenix Contact.
*1
)
*1 For details, please contact your local Phoenix Contact distributor.
Connecting the Power Cord
(1) Confirm that the power is not supplied to the PS-A unit.
(2) Unplug the power connector from the rear of the PS-A unit.
(3) Push the Opening button by a small and flat screw driver to open the desired pin hole.
(4) Insert each pin terminal into its each hole. Release the Opening button to clamp the pin place.
(5) After inserting all three pins, insert the Power Plug into the Power Connector at PS-A. Fix the plug with
two (2) minus screws.
Recommended Driver SZS 0.6x3.5 (1205053)
Recommended Pin Terminals
AI 0.75-10GY (3201288)
AI 1-10RD (3200182)
AI 1.5-10BK (3200195)
AI 2.5-12BU (3200962)
Recommended Pin Terminal Crimp Tool CRIMPFOX ZA3 (1201882)
• The power supply connector (plug) is CA7-DCCNL-01 (made by Pro-face) or GFKC2,5/
3-STF-7,62 (made by Phoenix Contact
*1
).
• The torque required to tighten these screws is 0.5 to 0.6N
•m.
• To prevent the possibility of a terminal short, use a pin terminal that has an
insulating sleeve.
24V
0V
FG
Opening Button
Power supply cord