Proface APL3000B - Node Box PC - Manual (Page 64)

Chapter 3 Installation and Wiring
3-7
(2) Unscrew the screws (2) from the Memory Slot Cover, and remove the cover.
(3) Angle the main memory module down slightly, and push it in until the connector pins mate with the
module's pins. Then, lower the module until it is horizontal and insert it completely into the connector.
This connector is shown in (2).
(4) Push in the main memory module until the stopper snaps into place.
(5) Replace the Memory Slot Cover and reattach two (2) attachment screws.
The torque should be 0.5 to 0.6N
•m.
(6) For PS-3450A Series, replace the Expansion Board Cover and reattach two (2) attachment screws lastly.
The torque should be 0.5 to 0.6N
•m.
3.2.2 Expansion Board (PCI) Installation
A PCI board, which is sold on the market, can be installed on PS-3450A.
• The Expansion Board (PCI) is corresponding to PS-3450A units.
• The maximum size allowed for a PCI board is 106.68mm [4.2in.] x 174.63mm
[6.88in.] .
Main Memory
Installation
Area
(PS-3450A)
(This figure is PS3450A-T41.)
Main Memory
Installation
Area
(PS-3451A)
Connector
Main Memory
Stopper
1
2