Structural specifications – Proface APL3000B - Node Box PC User Manual

Page 43

PS-3450A Series Hardware Manual

2-20

Structural Specifications

lation

Grounding

Grounding resistance of 100

Ω 2mm

or thicker wire,

or your country’s applicable standard.

(Same for FG and SG terminals)

Structure

The front face of the PS-A unit, installed in a solid panel, has been tested using

conditions equivalent to the standards shown in the specification. Even though the

PS-A unit’s level of resistance is equivalent to these standards, oils that should have

no effect on the PS-A can possibly harm the unit. This can occur in areas where ei-

ther vaporized oils are present, or where low viscosity cutting oils are allowed to ad-

here to the unit for long periods of time. If the PS-A’s front face protection sheet

becomes peeled off, these conditions can lead to the ingress of oil into the PS-A and

separate protection measures are suggested.

Also, if non-approved oils are present, it may cause deformation or corrosion of the

front panel’s plastic cover. Therefore, prior to installing the PS-A be sure to confirm

the type of conditions that will be present in the PS-A’s operating environment.

If the installation gasket is used for a long period of time, or if the unit and its gasket

are removed from the panel, the original level of the protection cannot be guaran-

teed. To maintain the original protection level, be sure to replace the installation gas-

ket regularly.

Rating: Equivalent to IP65f
Feature size: All-in-one
Installation configuration: Panel embedding, VESA Arm (only
for PS-3451A without built-in HDD unit)

Cooling Method

Natural air circulation

Weight

Approx. 3.5kg [7.7lb] max. (unit only)

External Dimensions

W230mm [9.06in] X H177mm [6.97in] X D65mm [2.56in]

Panel Cut Dimensions

W218.5mm [8.60in] X H165.5mm [6.52in]

Panel thickness: 1.6 [0.06in] to 10.0mm [0.39in]

As for dimensional tolerance everything +1/-0mm and R in angle are below R3.

Even if panel thickness is within recommend range for "Panel Cut Dimensions", the

panel could warp, depending on panel's material and installation location of PS-A or

other devices. To prevent panel warpage, the installation surface may need to be

strengthened.