Proface APL3000B - Node Box PC - Manual (Page 73)

PS-3450A Series Hardware Manual
3-16
(3) Fix the USB holder with a screw. The torque required for this screw is 0.5 to 0.6N
•m. Next, as shown,
insert the USB Cable Clamp’s band through the hollow of the holder. Pass the USB cables through the
Cable Clamp’s band and securely tighten the clamp band around the cables.
(4) For PS-3450A Series, replace the Expansion Board Cover and reattach two (2) attachment screws.
The torque required for these screws is 0.5 to 0.6N
•m.
„ Removing the USB Cable Clamp
(1) To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it while
pulling up on the clamp.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to
the side. This is to keep the clamp from interfering with nearby connectors and their
cables.
Band
Clamp
Cable collar
USB Cable
Clip
Clamp