Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 8)

8
UL/c-UL/CSA Approval
This unit is UL/c-UL/CSA listed product:
(UL File No. E210412, CSA File No.240854)
This product conforms to the following
standards:
• UL508
Industrial Control Equipment
• UL1604
Electrical Equipment for Use in Class I and
II, Division 2, and Class III Hazardous
(classified) Locations
• CSA-C22.2 No.142-M1987
Standard for Process Control Equipment
• CSA-C22.2 No.213-M1987
Non-Incendive Electrical Equipment for Use
in Class I, Division 2 Hazardous Locations
Warning - Explosion Hazard - This
equipment is suitable for use in Class I,
Division 2, Groups A, B, C, D or
nonhazardous locations only.
Warning - Explosion Hazard - Substitution of
components may impair suitability for Class
I, Division 2 compliance.
Warning - Explosion Hazard - Do not
disconnect equipment unless power has been
switched off or the area is known to be non-
hazardous.
CE Marking
• This unit is CE marked product that con-
forms to EMC directives, EN55011 Class
A and EN61131-2.
Digital Electronics Corporation
8-2-52 Nanko-higashi
Suminoe-ku, Osaka 559-0031
JAPAN
TEL : +81-(0)6-6613-3116
FAX : +81-(0)6-6613-5888
URL : http://www.pro-face.com/
© Copyright 2007 Digital Electronics Corporation.
All rights reserved.
- +
+
-
B’
B
+
-
A A’
+
-
OUT
IN0
+
-
NC
+
-
IN1
NC
+
-
A
B’
B
A
B’
B
*1
*1 For 4-wire cabling, output A’ is not connected.
4-wire cabling for Temperature Probes :
RTD
DC24V
DC
24V
Thermocouple
(K, J, T)
Shield
Analog voltage/
current input
device
Inquiry
Do you have any questions about
difficulties with this product?
Please access our site anytime that
you need help with a solution.
http://www.pro-face.com/otasuke/
Please be aware that Digital Electronics Corpora-
tion shall not be held liable by the user for any
damages, losses, or third party claims arising
from the uses of this product.
Note