Maple Systems HMI5000L Series - Manual (Page 2)

2 HMI5000L Installation Guide
1010-1018 Rev 01 www.maplesystems.com
Static Awareness
Do NOT remove the rear cover of your HMI5000L Series product –
doing so will void your warranty. When the rear cover is removed the
circuitry inside is exposed to possible damage by electrostatic discharge
during handling. Minimize the possibility of electrostatic discharge by:

Discharging personal static by grounding yourself prior to
handling the HMI.

Handling the HMI at a static-free grounded workstation.

Connecting the frame ground ( ) connector of the HMI to a
clean earth ground.

Placing the HMI in an antistatic bag during transport.
Unpacking the Unit
Carefully unpack the HMI. Please read any instructions or cautions that
appear on the shipping container. Check all material in the container
against the packing list. Maple Systems, Inc. will not accept
responsibility for shortages against the packing list unless notified within
30 days. The equipment and accessories were inspected and tested by
Maple Systems before shipment; all of the equipment should be in good
working order. Examine the equipment carefully; if any shipping damage
is evident, notify the carrier immediately. You are responsible for claim
negotiations with the carrier. Save the shipping container and packing
material in case the equipment needs to be stored, returned to Maple
Systems, or transported for any reason.
Packing List
HMI5000L Series Touchscreen
Power Connector
Mounting Clamps
Spare Fuse (Except HMI5043L)
HMI5000L Installation Guide