Maple Systems HMI5000L Series - Manual (Page 12)

12 HMI5000L Installation Guide
1010-1018 Rev 01 www.maplesystems.com
Figure 4: HMI Power Wiring
 To connect the HMI to power:
1. Connect the power cable to the HMI.
a. Strip the power cable shield to expose 2” of the black and
red wires.
b. Strip about ¼” of insulation from the black and red wires.
c. Connect the red wire to the 24V DC positive (+) input of the
HMI power terminal block.
d. Connect the black wire to the 24V DC negative (–) input of
the HMI power terminal block.
e. Connect the power cable shield wire to the HMI power
terminal block’s chassis ground input.
2. Route the power cable to the HMI power supply. The power
cable should not be any longer than necessary.