Maple Systems OMI5100A-CE - Manual (Page 4)

4 OMI5000 Series Installation Guide
1010-1013 Rev 01 www.maplesystems.com
the OMI will provide protection to the inside of the panel from splashing
water, wind-blown dust, rain, or hose-directed water. The OMI must be
installed according to the instructions in this manual to be properly
sealed.
Environmental Considerations
The OMI5000 Series is designed to operate in temperatures from 0° to
45°C (32° to 113°F). It is intended for indoor installations and may not
be suitable for use in certain outdoor applications. Avoid installing the
OMI5000 Series touchscreens in environments with severe mechanical
vibration or shocks. Do not install the OMI in enclosures with rapid
temperature variations or high humidity. Either will cause condensation
of water inside the device and eventual damage to the OMI.
Safety Precautions
Please observe the following precautions when installing the OMI.
Failure to comply with these restrictions could result in loss of life,
serious personal injury, or equipment damage.
Warning: Do not operate the OMI in areas subject to explosion
due to flammable gases, vapors, or dusts.
Warning: Do not connect the OMI to an AC power source. You
will cause permanent damage to the OMI.
Warning: Do not attempt to use a DC power supply that does
not meet OMI power requirements. You may cause malfunction
or permanent damage to the OMI.
Warning: Do not power the OMI with a DC power supply used
for inductive loads or for input circuitry to the programmable
logic controller. Severe voltage spikes caused by these devices
may damage the OMI.
Control Panel Design Guidelines
Pay careful attention to the placement of system components and
associated cable routing. These items can significantly enhance the
performance and integrity of your control application.