Maple Systems OMI5100A-CE - Manual (Page 12)

12 OMI5000 Series Installation Guide
1010-1013 Rev 01 www.maplesystems.com
2. Set the OMI in the panel cutout and hold it in place until all
clamps are in position.
3. Tighten the screw clamps in an even pattern until all are
uniformly snug.
Caution: Do not over-tighten the screws beyond snugness or
you may damage the housing.
Mounting Clamp Placement
Model Left Side Right Side Top Bottom
OMI5070A-CE 1 1 2 0
OMI5100A-CE 0 0 3 2
REINSTALLATION: If, at anytime, you are required to reinstall an
OMI into a panel, be aware that the gasket will take a ‘set’ to the panel
and may no longer provide an adequate NEMA 4 seal Therefore, for best
results, we recommend that you replace the gasket if reinstallation is
required.