Airlink CDMA/1x - Manual (Page 75)

Raven CDMA User Guide for Verizon, version 2.23 69
TCPS=n n = minutes
(TCPS=0) or
seconds
(TCPS=1) TCP connection time-out (TCPS) units. Specifies a time
interval upon which if there is no in or outbound traffic
through a TCP connection, the connection will be termi-
nated.
TCPT=n n = minutes
(TCPT=0) or
seconds
(TCPT=1) TCP connection time-out (TCPT) units. Specifies a time
interval upon which if there is no in or outbound traffic
through a TCP connection, the connection will be termi-
nated.
This value only affects the TCP connection in TCP PAD
mode.
&Cn n=0 | 1 | 2 Set DCD mode.
0 : Always assert DCD.
1 : Assert DCD when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
2 : Assert DCD when the modem has network coverage.
&Dn n=0 or 2 Set DTR mode.
0 : Ignore DTR, same effect as HW DTR always
asserted (same as S211=1).
2 : Use hardware DTR (same as S211=0).
&Sn n=0 | 1 | 2 Set DSR mode.
0 : Always assert DSR.
1 : Assert DSR when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
2 : Assert DSR when the modem has network coverage.
Note: S211 can also be used to request that DSR is
always asserted. If S211 is set to 3 and &S is changed to
a non-zero value, S211 will be changed to 1.
TABLE 6. Local Network and Host Modes
Command Parameters Details