Airlink CDMA/1x - Manual (Page 72)

66 Raven CDMA User Guide for Verizon, version 2.23
TABLE 6. Local Network and Host Modes
Command Parameters Details
+++
The "+" is ASCII 0x2B.
This command is not pro-
ceeded by AT.
none AT Escape sequence.
If the Raven is in a data mode (any mode other than
PassThru), this command causes the modem to re-enter
AT command mode.
Note: There must be an idle time (set by S50) on the
serial port before and after this command. The detection
of +++ is disabled if DAE=1.
AIP=n n=0
n=1
Allow only the IP specified in S53 to connect when UDP
auto answer is enabled (S82=2).
Allow any incoming IP to connect when UDP auto
answer is enabled (S82=2).
Always subject to any Friends filters that may be
defined.
HOR=n
n=0
n=1
Half-Open Response - In UDP auto answer (half-open)
mode:
No response codes when UDP session is initiated.
RING CONNECT response codes sent out serial link
before the data from the first UDP packet.
Note: Quiet Mode must be Off.
MDhh hh (hex byte) =
00 - normal
mode
01 - SLIP mode
02 - PPP mode
03 - UDP mode
04 - TCP mode
07 - PassThru
mode
Default power-up mode.
When the PinPoint is power-cycled, it may enter the
mode specified by this command after 5 seconds. On
startup, typing ATMD0 within 5 seconds changes the
mode to normal (AT command) mode.
See also S53 to set the port for UDP or TCP.