Airlink CDMA/1x - Manual (Page 67)

Raven CDMA User Guide for Verizon, version 2.23 61
Basic Commands
These commands are common to most communication devices using AT Com-
mands.
TABLE 3. Basic Commands (common AT commands)
Command Parameters Details
+++
The "+" is ASCII 0x2B.
none AT Escape sequence.
Not proceeded by AT.
If the Raven is in a data mode (any mode other than
PassThru), this command causes the modem to re-enter
AT command mode.
There must be an idle time (set by S50) on the serial port
before and after this command.
The detection of +++ is disabled if DAE=1.
A/ none Re-execute last command.
Not proceeded by AT.
A none Answer - manual
DAE=n n=0 or 1 Disable AT Escape Sequence detection.
0 : Enable +++ AT escape sequence detection.
1 : Disable +++ AT escape sequence detection.
En n=0 or 1 Toggle AT command echo mode.
0 : Echo Off
1 : Echo On
Hn n=1 Hang-Up Command.
1: Hang-up
Note: With an AT telnet connection, this command will
terminate the host data mode and return the Raven to an
AT mode.
O none Online (Remote): Causes the Raven to go from Com-
mand State to data state.