IEI Integration AFL-15i-HM55 v2.00 - Manual (Page 55)

AFL-HM55 Series Panel PC
Page 44
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 3-23 n).
Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges
of the panel mounting brackets (Figure 3-23 o). There are a total of 4 panel
mounting clamps for AFL-HM55 Series.
Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
(Figure 3-23 p).
Figure 3-23: Panel Mounting