IEI Integration ECN-780-Q67 - Manual (Page 28)

ECN-780-Q67 Em b e d d e d S ys te m
P a g e 15
S te p 3: Attach the HDD to the HDD bracket, and then slide the HDD to connect the HDD
to the SATA connector. Secure the HDD with the HDD bracket by four retention
screws (Figure 3-3).
Figure 3-3: HDD Retention Screws
S te p 4: Replace the HDD cover and secure it using five (5) previously removed retention
screws.
3.4 AT/ATX Mo d e S e le c tio n
AT or ATX power mode can be used on the ECN-780-Q67. The selection is made through
an AT/ATX switch located on the rear panel (Figure 3-4). To select AT mode or ATX mode,
follow the steps below.
S te p 1: Locate the AT/ATX switch on the rear panel (Figure 3-4).