IEI Integration ECN-780-Q67 - Manual (Page 26)

ECN-780-Q67 Em b e d d e d S ys te m
P a g e 13
3.1 In s ta lla tio n P re c a u tio n s
During installation, be aware of the precautions below:
 Read the user manual: The user manual provides a complete description of
the ECN-780-Q67, installation instructions and configuration options.
 DANGER! Disconnect Power: Power to the ECN-780-Q67 must be
disconnected during the installation process, or before any attempt is made to
access the rear panel. Electric shock and personal injury might occur if the
rear panel of the ECN-780-Q67 is opened while the power cord is still
connected to an electrical outlet.
 Qualified Personnel: The ECN-780-Q67 must be installed and operated only
by trained and qualified personnel. Maintenance, upgrades, or repairs may
only be carried out by qualified personnel who are familiar with the associated
dangers.
 Grounding: The ECN-780-Q67 should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the ECN-780-Q67.
3.2 In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1: Unpack the ECN-780-Q67.
S te p 2: Install the HDD.
S te p 3: Configure the system.
S te p 4: Connect peripheral devices to the ECN-780-Q67.
S te p 5: Mount the ECN-780-Q67. S te p 0:
3.3 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1: Remove five (5) retention screws from the HDD cover (Figure 3-1).