IEI Integration NANO-PV-D4252_N4552_D5252 - Manual (Page 59)

NANO-PV-D4252/N4552/D5252 EPIC SBC
Page 45
Before the NANO-PV-D4252/N4552/D5252 is installed in the system, the jumpers must be
set in accordance with the desired configuration. The jumpers on the
NANO-PV-D4252/N4552/D5252 are listed in
6
Table 4-1.
Description Type Label
AT Auto Button 2-pin header J_AUTOPWR1
Clear CMOS 3-pin header J_CMOS1
CompactFlash® Master/Slave function setting 2-pin header JCF1
CompactFlash® voltage select 2-pin header J_VCF1
COM3 RS-232/422/485 select 6-pin header J4
COM3 RS-422/485 select 6-pin header J6
COM3 RS-422 Termination select 2-pin header J10
COM3 RS-485 Termination select 2-pin header J9
LVDS1 LCD Voltage select 6-pin header J_VLVDS1
LVDS2 LCD Voltage select 6-pin header J_VLVDS2
LVDS1 LCD panel type 8-pin header J_LCD_TYPE1
LVDS2 LCD panel type 6-pin header JP2
Table 4-1: Jumpers
4.5.1 AT Auto Button Power Select Jumper Settings
Jumper Label: J_AUTOPWR1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-2
The AT Auto Button Power Select jumper specifies the systems auto button power mode
as AT or ATX.
Setting Description
Short Use AT power