IEI Integration NANO-PV-D4252_N4552_D5252 - Manual (Page 57)

NANO-PV-D4252/N4552/D5252 EPIC SBC
Page 43
 Turn all power to the NANO-PV-D4252/N4552/D5252 off:
o When working with the NANO-PV-D4252/N4552/D5252, make sure that it
is disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the NANO-PV-D4252/N4552/D5252 DO NOT:
 Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
 Use the product before verifying all the cables and power connectors are
properly connected.
 Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 Unpacking
When the NANO-PV-D4252/N4552/D5252 is unpacked, please check all the unpacking
list items listed in Chapter 3 are indeed present. If any of the unpacking list items are not
available please contact the NANO-PV-D4252/N4552/D5252 vendor reseller/vendor
where the NANO-PV-D4252/N4552/D5252 was purchased or contact an IEI sales
representative.
4.4 SO-DIMM Installation
SO-DIMM is a critical component of the NANO-PV-D4252/N4552/D5252. If it is not
installed the NANO-PV-D4252/N4552/D5252 cannot run.