IEI Integration KINO-9652 v1.11 - Manual (Page 44)

KINO-9652 Mini-ITX SBC
Page 22
2.6.9 Intel
®
ICH8ME SATA Controller
The integrated SATA controller on the ICH8ME supports two SATA II drives on the
KINO-9652 with independent DMA operations. SATA controller specifications are listed
below.
Supports two SATA II drives
Supports 3 Gb/s data transfer speeds
Supports Serial ATA Specification, Revision 1.0a
Figure 2-11: SATA Drive Connectors
2.6.10 Intel
®
ICH8ME Serial Peripheral Interface (SPI) BIOS
The 4-pin SPI is connected to an SPI BIOS chip. A licensed copy of AMI BIOS is
preinstalled on the SPI BIOS chip. A master-slave protocol is used for communication on
the SPI bus. The slave is connected to the Intel® ICH8ME and is implemented as a
tri-state bus.
2.6.11 Intel
®
ICH8ME USB Controller
Up to eight high-speed, full-speed or low-speed USB devices are supported by the
ICH8ME on the KINO-9652. High-speed USB 2.0, with data transfers of up to 480MB/s, is
enabled with the ICH8ME integrated Enhanced Host Controller Interface (EHCI) compliant
host controller. USB full-speed and low-speed signaling is supported by the ICH8ME
integrated Universal Host Controller Interface (UHCI) controllers.