IEI Integration KINO-9652 v1.11 - Manual (Page 102)

KINO-9652 Mini-ITX SBC
Page 80
Description Label Type
Clear CMOS J_CMOS1 3-pin header
COM 4 function selection JP5 6-pn header
COM port RI and voltage selection JP1, JP2 10-pin header
LVDS LCD voltage selection J_VLVDS1 3-pin header
LVDS LCD resolution selection JP3 8-pin header
CF card setup (optional) JCF1 2-pin header
Table 5-1: Jumpers
5.4.1 Clear CMOS Jumper
Jumper Label: J_COMS1
Jumper Type: 3-pin header
Jumper Settings: See Table 5-2
Jumper Location: See Figure 5-8
If the KINO-9652 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.