WEATHER GUARD 1450 - Manual (Page 8)

LIMITED WARRANTY
This LIMITED WARRANTY is made by Knaack LLC, 420 E. Terra Cotta Ave., Crystal Lake, Illinois to the original retail purchaser of KNAACK® or WEATHER
GUARD® products.
KNAACK LLC WARRANTS THAT KNAACK OR WEATHER GUARD PRODUCTS WILL BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A
PERIOD OF TWO (2) YEARS FROM DATE OF PURCHASE BY THE ORIGINAL RETAIL PURCHASER.
If, before the expiration of the Warranty period, purchaser discovers that the KNAACK or WEATHER GUARD product fails to fulfill the Warranty, purchaser shall
contact Knaack LLC to make arrangements for an inspection of the product. If Knaack LLC determines a defect exists, Knaack LLC shall, at its option and expense,
repair or replace any defective part. All Warranty repairs shall be made by an authorized KNAACK Product dealer or Knaack LLC approved service company.
This Warranty shall not apply if the KNAACK or WEATHER GUARD product has been subjected to misuse, abnormal service or handling, improper maintenance,
or alterations made by anyone other than a KNAACK or WEATHER GUARD Product dealer or a Knaack LLC approved service company.
THE WARRANTY PRINTED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PURCHASE. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY
DISCLAIMED.
KNAACK LLC SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF ANY BREACH OF
THIS WARRANTY. NOR SHALL THE DAMAGES EXCEED THE RETURN AMOUNT OF THE PURCHASE PRICE PAID BY THE ORIGINAL PURCHASER.
This Warranty is in lieu of all Warranties express or implied. The terms of this Warranty shall not be modified by any party, their successors or assigns. This
Warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Product fits based on vehicle design available at the revision date. Vehicle manufacturers may change specs after the revision date, so if you have a
vehicle produced with a model year date after the revision date, please contact your distributor or Knaack LLC to verify fitting of product to vehicle.
WEATHER GUARD Products are protected by one or more of the following patents: U.S. 5145087, 5308126, 4509787, 4573731, 4618083, D-346355,
D-346994, D-353574; Canada 1218968, 1224230, 1235100 and; U.K. 2233036. Other patents pending .
KNAACK LLC
420 E. Terra Cotta Ave, Crystal Lake, IL 60014, 1-800-456-7865
WWW.WEATHERGUARD.COM
©2004 Knaack LLC
Figure 6
FIGURE 6: BLIND FASTENER INSTALLATION
Note: Make sure there is enough hole depth before installing
the Blind Fastener.
Note: Black Oxide Bolt, Flat Washer, and Installation Tool are
only used to install Blind Fasteners.
• Place a drop of oil on the black oxide bolt for lubrication.
• Insert Blind Fastener in the hole.
• Hold the “Installation Tool” with a 9/16” wrench while
turning the “Black Oxide Bolt” with a 1/2” wrench until
fully seated.
• Make sure the blind fastener and installation tool do not
turn while tightening.
• Turning “Black Oxide Bolt” will be hard until fastener
“bulbs” out.
• When Blind Fastener is fully seated, remove the black
oxide bolt and washer and continue with the installation
directions.
Black Oxide Bolt
Flat Washer
9/16" Wrench
Installation Tool
Blind Fastener
BlindFastInstall(Fig.7).eps
8 Part No. 24-0192 REV. C ECN 5315 05/13