AMX NXD-CV7 - Manual (Page 44)

Installation
36 7" Modero Widescreen Touch Panels
1. Remove any screws or nails from the drywall before beginning.
2. Cut out the surface for the NXD Wall Mount unit using the dimensions shown in FIG. 36. Be
sure to cut out the three notches along the sides to accommodate the three corresponding
drywall expansion clips (included).
3. Remove the Faceplate/bezel (A in FIG. 37) from the main NXD unit (B in FIG. 37) by
gripping the faceplate and pulling with gentle outward force.
4. Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from
their terminal locations) through the surface opening. Leave enough slack in the wiring to
accommodate any re-positioning of the panel.
5. Connect all data and power wiring connectors to their corresponding locations along the left
side of the (un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
FIG. 36 NXD-CV7 Wall Mount panel dimensions using expansion clips