AMX NXD-CV7 - Manual (Page 27)

CV7 Touch Panel Accessories
19 7" Modero Widescreen Touch Panels
9. Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.
10. Insert all connectors and apply power.
Installation of the Wireless Card (WallMount Panel)
These procedures involve removing the outer housing, installing the wireless card, and then
securely replacing the outer housing back onto the NXD panel.
The CV7 panels do not come factory installed with the NXA-WC802.11B/CF wireless
interface card. This card must be ordered separately from AMX.
Step 1: Removing the existing NXD Outer Housing
1. Detach all connectors from the side of the touch panel.
2. Remove the faceplate from the CV7.
3. Place the LCD facedown on a soft cloth to expose the under-side of the unit (FIG. 20) and
prevent scratching of the LCD.
4. Firmly press down on both connector overlay release latches (located in front of the
connectors). Pressing down releases the connector overlay from atop the connectors.
5. Gently slide the connector overlay away from the back box housing.
6. Unscrew the outer housing (back box) by using a grounded Phillips-head screwdriver to
remove the two sets of pan-head Housing Screws, located on other side of the connector
overlay (FIG. 20).
FIG. 20 Location of the attachment screws and connector overlay release latches on an NXD back box
Unscrew these
four pan-head
Two (2) connector
housing screws
to remove the
back box
overlay release latches
(2 per side)
The overlay connector must first be released before the rear back box can be
removed from the NXD-CV7 panel.