AMX NXD-CV7 - Manual (Page 40)

Installation
32 7" Modero Widescreen Touch Panels
8. Gently insert the Button Trim Ring latches into their corresponding openings on the outer
surface of the internal Faceplate (FIG. 33).
9. Firmly press down around the Button Trim Ring until all of the latches are securely inserted
into their openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the
Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this
Trim Ring and the outer surface of the Faceplate.
10. Place the Faceplate back onto the main NXD-CV7 unit. Make sure to align the Microphone,
Light, and PIR Motion sensor locations on the main unit to their respective openings on the
Faceplate assembly.
FIG. 32 Removing the No-Button Trim Ring
FIG. 33 Inserting the Button Trim RIng
No-Button Trim Ring
Trim
Faceplate
CV7 Panel/enclosure
Ring
Latches
(outside surface shown)
Button latch
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the internal surface of Faceplate)
Button openings
Button Trim Ring
Faceplate (outer surface shown)