AMX NXD-CV7 - Manual (Page 33)

CV7 Touch Panel Accessories
25 7" Modero Widescreen Touch Panels
7. Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop
the battery base.
8. Slide the rear battery locking slider in the opposite direction. This turns the latching
mechanism and secures the panel to the base.
9. Upon successful connection, the AMX logo appears on the panel to indicate that the panel is
properly connected and receiving power.
Charging the NXT-BP using the NXA-BASE/1
1. Insert the single battery into the battery compartment shown in FIG. 26 on page 24.
2. Follow the procedures from the previous sub-section to attach the NXT-CV7 to the
NXA-BASE/1.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT-CV7
Modero panel. Refer to the Battery Base Page section on page 95 to view the charging progress
of the connected NXT-BP.
NXT-CHG Battery Charger Kit (FG2255-50K)
The NXT-CHG Kit includes one charger and two NXT-BP batteries. The optional NXT-CHG
Modero Power Station (FIG. 28) is a two-slot, stand-alone battery charger that can be used to
recharge up to two NXT-BP batteries. The batteries are charged in the order they are inserted into
the charger. The NXT-CHG Slot 1 has the feature of being able to completely discharge and
recharge (recalibrate) a battery.
The battery base CANNOT be hot-swapped. An NXT can not be receiving power
(through a connected power supply) and then be connected to a battery base. Always
POWER OFF the panel before installing the NXA-BASE/1.
FIG. 28 NXT-CHG Kit (consists of one NXT-CHG charger and two NXT-BP batteries)
NXT-CHG Modero Power Station (charger)
NXT-BP Modero Power Pack (battery)
Battery Life indicator