AMX NXD-CV7 - Manual (Page 25)

CV7 Touch Panel Accessories
17 7" Modero Widescreen Touch Panels
8. In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and
then out (away from the LCD panel) to expose the internal circuit board (FIG. 17).
Step 2: Upgrading internal components (Compact Flash and Wireless cards)
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the 64 MB Compact Flash and Wireless Interface cards on the main board (FIG. 18).
3. Insert a grounded flathead screwdriver into one of the card removal grooves (located on either
side of the card), and gently pry the card up and off the connector pins. Repeat this process on
the opposite card removal groove. This alternating action causes the card to "wiggle" away
from the on-board connector pins.
4. Slip your finger into the opening between the connector pins and the card, and push the card
out to remove it.
5. Remove the upgrade card from it’s anti-static bag.
FIG. 17 Removal of the outer housing and wireless card location
FIG. 18 Location and orientation of the card slots (both CV7 panels)
Outer housing
Tilt Bracket cover plate
Base
Outer Housing
installation holes
(located on front panel)
(must be removed first)
Compact Flash Card
(Slot 1)
Wireless Interface Card
(Slot 2)
Card removal grooves
Card Removal Grooves
Front of panel
Tilt Bracket