Vanguard ATO-600P User Manual

Page 28

ATO-400P / ATO-600P Operating Procedures

7.5 Enter Record ID Procedure

This procedure allows the user to enter the equipment identification data to the test record.

Table 7.0 Enter Record ID Procedure (test-record, site, and equipment identification)

STEP

ACTION

ATO DISPLAY

7-1

Press key # 2 on the START MENU to go
to the SETUP MENU shown at right.
Note: Setup options 2 thru 4 go to the
following procedural tables:
2. REVIEW RECORD procedures in
Table 8.0
3. RESTORE RECORD Procedures in
Table 9.0
4. NEXT PAGE procedures in Table 12.0.

7-2

On the SETUP MENU, press key #1
(ENTER ID) to begin entering
identification data begining with the
“COMPANY” input screen.
Note: See Section 7.1.4 for instructions on
entering alpha/numeric characters with the
keypad.

7-3

Enter the utility COMPANY name using
the alpha/numeric keypad. Press
“ENTER” to load the entered characters
and advance to the “STATION” input
screen.

7-4

Enter the utility STATION name using the
alpha/numeric keypad. Press “ENTER” to
load the entered characters and advance to
the “CIRCUIT” input screen.

7-5

Enter the test item’s CIRCUIT name using
the alpha/numeric keypad. Press
“ENTER” to load the entered characters
and advance to the “MANUFACTURER”
input screen.

7-6

Enter the test item’s MANUFACTURER
name using the alpha/numeric keypad.
Press “ENTER” to load the entered
characters and advance to the “MODEL”
input screen.

1. ENTER RECORD ID
2. REVIEW RECORD
3. RESTORE RECORD
4. NEXT PAGE

COMPANY: