Vanguard ATO-600P - Manual (Page 12)

ATO-400P / ATO-600P Operating Procedures
12
Table 3.0 Functional Description of ATO-400P Controls and Display
Figure 1
Index #
Adjacent Panel Marking Functional Description
1 & 13 (Wing Nut) Current lead connectors.
2 USB USB connector. USB port is for factory
calibration, firmware updates, and interfacing
with the software program supplied with each
ATO.
3
RS-232C
RS-232C interface port; 9-pin connector;
female DB type. The data are set to 115,200
baud, 1 start bit, 8 data bits, and no parity bit;
PIN ............... SIGNAL
2 Rx
3 Tx
5 Signal Gnd
This serial port is for factory calibration,
firmware updates, and interfacing with the
software program supplied with each ATO.
4 HIGH CURRENT
PRESENT
LED indicator, red; Lights when test current
is flowing through the current test leads.
5 No Marking Input power connector with third-wire safety
ground.
6 GROUND
(Wing Nut)
ATO-400P ground stud. Connect ground stud
to substation ground using provided cable.
7 No Marking Circuit breaker, 25A.
8
No marking
Built-in thermal printer, prints test result data
on 2.5-inch-wide thermal paper.
9
No marking
LCD; 4-line by 20-character; back-lighted;
displays menus of selections, operator entries,
and test-measurement results.
10
No marking
Operating key-pad controls, 10 alpha-numeric
keys and 6 function keys (START, STOP,
CLEAR, ENTER, & CONTRAST/PAPER
positioning
?
&
?
).
11 & 12 (Resistor Symbol) Voltage-sensing connector jacks (red).