Anritsu 681XXC - Manual (Page 64)

Open the parameter you wish to change, then edit
the current value using the cursor control key or the
rotary data knob or enter a new value using the key
pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or make another menu
selection.
Press More to go to the Additional Step Sweep
Ramp menu.
Press Previous Menu to return to the Step Sweep
Menu display.
Additional Step Sweep Ramp Menu
When you press More, the Additional Step Sweep
Ramp Menu (below) is displayed.
This menu lets you set the sweep time, select loga-
rithmic or linear step sweep, and go to the trigger
menu.
To open the sweep time parameter for editing, press
Sweep Time . Edit the current sweep time using the
cursor control key or the rotary data knob or enter a
new sweep time using the keypad and appropriate
terminator key. To close the open sweep time pa-
rameter once you have set the desired time, press
Sweep Time or make another menu selection.
Press Log/Linear to select logarithmic or linear step
sweep operation. The soft-key label is highlighted
(in reverse video) to reflect your selection.
Press Trigger Menu to go to the Step Sweep Trigger
menu. The trigger menu lets you select a sweep trig-
ger (previously described on page 3-28).
Press Previous Menu to return to the Step Sweep
Ramp Menu display.
681XXC OM 3-31
LOCAL (FRONT SWEEP FREQUENCY
PANEL) OPERATION OPERATION