Anritsu 681XXC - Manual (Page 57)

Scanning Tagged Frequencies–To go to the
Tagged Frequencies Menu (below) from the CW Fre-
quency Control menu, press
Tag Freq Menu .
This menu lets you select the tagged frequencies for
output using the
Scan Up and Scan Dn keys.
Return to the CW Frequency Control Menu display
by pressing
Previous Menu .
Selecting a
Power Level While in the CW frequency mode, you can edit the
current CW frequency output power level or enter a
new output power level.
Editing the Current Power Level
Press
Edit L1 to open the power level parameter,
then edit the current power level using the cursor
control key or rotary data knob. To close the open
power level parameter, press
Edit L1 or make an-
other menu selection.
Entering a New Power Level
Press
Edit L1 to open the power level parameter,
then enter the new power level using the keypad
and appropriate terminator key. To close the open
power level parameter, press
Edit L1 or make an-
other menu selection.
NOTE
You can also select any of the preset
power levels or a power level sweep for a
CW frequency. For instructions, refer to
paragraphs 3-9 (Fixed Power Level Op-
eration) and 3-10 (Power Level Sweep
Operation).
3-24 681XXC OM
LOCAL (FRONT CW FREQUENCY
PANEL) OPERATION OPERATION