Teledyne LeCroy LSIB-1 Host Interfaces - Manual (Page 39)

Operator's Manual
LSIB-OM-E Rev C 33
Specifications
NOTE: Specifications are subject to change without
notice.
Please refer to the Teledyne LeCroy website at
teledynelecroy.com for the most current specification
information regarding your product.
Certifications
This section contains LSIB-
1 Host Interface’s Electromagnetic
Compatibility (EMC), Safety and Environmental certifications.
EC Declaration of Conformity - EMC
This oscilloscope accessory meets intent of EC Directive
2004/108/EC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official
Journal of the European Communities:
EN 61326-1:2006, EN 61326-2-1:2006 EMC requirements for
electrical equipment for measurement, control, and laboratory use.
EC Declaration of Conformity
– Low Voltage
This oscilloscope accessory meets intent of EC Directive
2006/95/EC for Product Safety. Compliance was demonstrated to
the following specifications as listed in the Official Journal of the
European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use
– Part 1: General
requirements
EN 61010-2:030:2010 Safety requirements for electrical
equipment for measurement, control, and laboratory use
– Part 2-
030: Particular requirements for testing and measuring circuits