Teledyne LeCroy LSIB-1 Host Interfaces - Manual (Page 15)

Operator's Manual
LSIB-OM-E Rev C 9
Installation
1. Shut down the host PC in which you are installing
the card.
2. Open the chassis according to your PC
documentation and let the power supply cool down
(if necessary).
3. Install LSIB-HOSTBOARD into a PCIe x4, x8, x16
add-in card slot. Make sure the card is well seated
and tighten the screw.
NOTE: Motherboard manufacturers may limit the
bandwidth to x1 speeds when up-plugging the
Target Cable Adapter into an x8 or x16 slot. Be
sure to check with the motherboard manufacturer
for up-plugging details. A PCIe x4 board does not
physically fit in a x1 slot.
4. Attach the cable by first pulling on the retractor
ring which releases the locking mechanism.
Connection ends are interchangeable and allow for
upstream and downstream transfers.
5. Push the cable into the ExpressCard slot until it
locks into place.
6. Attach the other end of the cable to the
oscilloscope.