Teledyne LeCroy LSIB-1 Host Interfaces - Manual (Page 26)

LSIB-1 Host Interfaces
20 LSIB-OM-E Rev C
Remote Control Commands
NOTE: Legacy remote control commands may be used
via the Remote Interface. Please refer to the Remote
Control and Automation manuals for more information.
Enter a remote command to test the connection is
operating correctly. Some examples of remote control
commands include:

C1:VDIV? - Queries the Volt/Div the oscilloscope is
setup on Channel 1.

C1:VDIV 100mv - Sets C1 of the oscilloscope to 100
mv/div.
W INDOWS