Teledyne LeCroy LSIB-1 Host Interfaces - Manual (Page 16)

LSIB-1 Host Interfaces
10 LSIB-OM-E Rev C
NOTE: Reverse these steps to remove the cable and the
LSIB-HOSTBOARD being sure to first pull the cable's
retractor ring which releases the locking mechanism
before removing the cable.
Powering Sequence
The connection from the oscilloscope to the PC or Laptop
is not "plug-and-play." You must first power on the
oscilloscope, then the PC/Laptop. However, you do not
have to wait for the oscilloscope software to fully load
before powering on the PC.
NOTE: At power on, your PC/Laptop may indicate it has
found new hardware. Be sure to click Cancel if prompted
to install drivers. Install the drivers using the CD provided
with the Interface. Do not disconnect cables while your
Laptop/PC and the instrument are powering up.
Laptop or PC Application and Driver
Installation
Instead of using the installation CD provided with the
Interface, the software can also be accessed from the
Teledyne LeCroy website at teledynelecroy.com.
Cancel Found New Hardware Procedure on the
Laptop or PC if Prompted
After installing the LSIB-HOSTCARD or LSIB-HOSTBOARD
and powering on, if your computer shows a Windows
Found New Hardware prompt, cancel the operation and
instead run the installation CD.
NOTE: It's very important to use the installation CD
and not the Found New Hardware function.