Staub Electronics ZVPRO810 ZEEVEE - SINGLE CHANNEL DIGITAL VIA UNENCRYPTED HDMI - Manual (Page 5)

ZvPro 800 Series Modulator Get Going Guide Page 5 of 8
v.08062013
Factory default settings in the product allow ZvPro Series modulators to broadcast up to two unencrypted
HDMI sources on RF channels 2 and 3 for reception at connected HDTVs.
1. Connect the power supply and apply AC power.
2. Using an HDMI cable, connect the video source to the HDMI Input port on the ZvPro.
3. For Closed Captioning (optional), connect a composite cable from the video source to the Caption port
on the ZvPro.
4. Connect the RF Output of the ZvPro to your RF network. Output power of the ZvPro defaults to
+25dBmV. Can be set between +25dBmV and +45dBmV using the Maestro web interface (see page 5).
5. Set the RF input on the TV to Cable Mode (not Air or Antenna).
6. Tune HDTVs to cable channels:
NOTE: Many TVs require a full
channel scan to find the channels.
7. Optional: Go to Advanced
Configuration in Maestro to set
up Delay Matched Audio.
ZvPro
Input 1
RF #
2
ZvPro
Input 2
(ZvPro820 only)
RF #
3
AV Input 1
HDTV
Channel
2.1
AV Input 2
HDTV
Channel
3.1
ZvPro800 Basic Installation
+25dBmV
RF Output
Coax cable connects
to coax network
Optional Analog Audio out to
audio system
Video Source
Audio System
4:1
splitters
Coax out
10’s or
100’s or even
1,000’s of HDTVs
Combiner
Other
+25dBmV
Sources
Composite
Video
f
or Close
d
Cap
tioning
Unencrypted
HDMI Out
Analog
Audio