Staub Electronics SR-CS-RACK-21U STRONG - CONTRACTOR SERIES 21U WITH SIDE PANELS AND FINES FLOOR CASTERS - Manual (Page 2)

Strong™ CONTRACTOR SERIES RACKS
Strong ™ equipment racks are solid steel and feature fully enclosed
steel side panels. They are available in three sizes: 12-space, 16-space
and 21-space. The racks are set upon 4 heavy-duty, 3-inch (75 mm) rubber
casters with locking fronts. Each equipment rack includes a 1U blank panel
for support on the back side of rack. The unique front and back pillar
construction allows the racks to be assembled to accept either Metric
or English Standard thread sizes. The inside of each pillar has a removable
sticker which points to the corresponding thread pattern - Metric (to use
M6 rack screws) or English Standard (to use 10/32 rack screws).
RACK SIZE OPTIONS
Equipment racks are
available in three sizes:
• 12 space
• 16 space
• 21 space.
PARTS INCLUDED
1. Top Plate
2. Side Plate
3. Front Pillar
4. Back Pillar
5. Base Plate
6. Casters (4)
7. Rack Assembly Screws
8. 1U Blank Plate
RACK ASSEMBLY
Lock the casters before starting assembly.
• First ensure that the four pillars are arranged with threaded screw
holes facing outwards.
Note: Sticker on inside of each pillar points to the location
of Metric and English Standard thread pattern.
With the base plate (part #5) flat on the ground, use three of the
supplied rack assembly screws (part #7) to attach each side plate (
part #2) so that the inner flange is flat against the base plate.
• On either side of each side plate, screw in the bottom of the pillars
using two rack assembly screws (part #7) per pillar (parts #3 and #4)
with the inner flange sitting flat against the base. One side of the
threaded screw holes in each pillar should be facing outwards,
either Metric or English Standard.
• Place the top plate (part #1) over the sides of the rack so that the four
pillars and side plates fit inside the top plate and attach using eighteen
supplied rack assembly screws. For extra stability, install 1U Blank Plate
(part #8) to upper most position on back side of the rack.
1
5
7
6
2 3
4
8
MODEL
DEPTH RACKING
HEIGHT
W/ CASTERS
HEIGHT
WIDTH
“A” “B” “C” “D”
SR-CS-RACK-12U 18.11” 23.62” 27.55” 19.96”
SR-CS-RACK-16U 18.11” 30.70” 34.65” 19.96”
SR-CS-RACK-21U 18.11” 39.37” 43.31” 19.96”
CAUTION:
This rack is intended for use only with shelf models
SR-SHELF-2U,-3U,-4U, and -5U with a maximum combined
load of 600 pounds. Use with heavier than the maximum
load indicated may result in instability causing possible injury.
SR-CS-RACK-12U SR-CS-RACK-16U SR-CS-RACK-21U
D
FRONT VIEW SIDE VIEW
A
C
w/CASTERS
B
REAR VIEW