Data capture—barcode scanning xt85 user manual – Janam XT85 User Manual
Page 48

Data Capture—Barcode Scanning
XT85
User Manual
Janam Technologies LLC
6
―6
Scanning Demonstration
Note:
The
ScanWedge
function must be enabled for the
Scan Demo
function to operate.
The
ScanWedge
function will be disabled if manual scanning is initiated either by a
command API or by using the Janam Barcode Test Program.
To configure ScanWedge and enable
Symbologies:
1. From the Windows Mobile Start
screen scroll down and tap Utilities
(folder) > ScanWedge (icon).
2. Set preferences with individual pull-
down menus for ScanWedge, Beep
Sound and Light Mode.
3. Enter
Prefix to send before
barcode and Suffix to send after
barcode or leave blank.
4. Check or clear box options.
5. Tap Menu > Setup >
Symbology Config.
6. Tap Enable All to enable all barcode
types or manually select the
barcode type(s) to enable.
7. Tap OK to save.
8. Tap
Menu (Taskbar) > Setup >
Hardware Test to confirm that all
scanner functions are working
properly.
9. Select
(check)
each Hardware Test
item individually to verify proper
functioning.
10. Tap OK.
11. Tap Apply to enable ScanWedge.