beautypg.com

Janam XT85 User Manual

Page 11

background image

Getting Started

XT85

User Manual

Janam Technologies LLC

2

―5

Attach the Handstrap

1. Insert the plastic fastener

on the handstrap facedown into the XT device handstrap retainer clip

until it clicks securely into place.

2. Extend the other end of the handstrap toward

the base of the XT device (with the rough side
of the Velcro facing up). Feed it through the
hand strap bar as shown in the diagram

.

3. Pull handstrap through handstrap bar and

fasten Velcro

to secure the strap. Adjust

the Velcro as needed to fit and secure the XT
device to the user’s hand.

 

Note:

Because the handstrap can interfere with the camera lens, be aware
of its positioning when capturing images.

Turn the XT Series Device On

With a fully charged battery installed, press and release
the red Power button (at the bottom right-hand corner
of the keypad). Pressing the power button again will suspend
the XT Series device’s operation. Holding the power button
for an extended time will not reboot the device.

See Chapter 4 for additional information about On
(Resume), Off (Suspend) and Reset functions.

Note:

Power button image shown represents the QWERTY keyboard model.
The Numeric keyboard differs, but its power button is identical.

 

IMPORTANT NOTE!

 

Always use the supplied stylus for tapping or making strokes on the screen.

DO NOT use a pen, pencil or any other object on the touch screen.

Note:

If your XT Series device came pre-loaded with a custom software
application, a welcome utility may not appear. If this happens,
follow the on-screen instructions.

Power