Data capture—barcode scanning xt85 user manual, A. laser-based configurations – Janam XT85 User Manual
Page 44

Data Capture—Barcode Scanning
XT85
User Manual
Janam Technologies LLC
6
―2
A. Laser-Based Configurations
This section is specific to XT Series configurations equipped with
Motorola SE965HP laser scanning technology. Please see Section B
for barcode scanning with XT Series configurations with Adaptus Imager
scanning technology.
Scanning Demonstration
Note:
The
ScanWedge
function must be enabled for the
Scan Demo
function to operate.
The
ScanWedge
function will be disabled if manual
scanning is initiated either by a command API or by
using the Janam Barcode Test Program.
When the ScanWedge feature is enabled, data can be entered into the specified application by opening
the application on the handheld and scanning a barcode.
To enable ScanWedge and set
Symbology Configurations:
1. From the Windows Mobile Start screen
scroll down and tap Utilities (folder) >
ScanWedge (icon).
2. Set preferences using pull-down menus
for ScanWedge, Beep Sound and
Light Mode.
3. Enter
Prefix to send before barcode
and
Suffix to send after barcode or
leave blank.
4. Check or clear box options.
5. Tap Menu > Setup >
Symbology Config.
6. Tap Enable All to enable all barcode
types or manually select the barcode
type(s) to enable.
7. Tap OK to save.