SKC DataTrac for the Leland Legacy - Manual (Page 35)

32
SKC Pump History
Clear Pump History
To clear the pump history, select Clear History from the Tools menu.
Change Options*
To change display and sample interval pump history options, select Options from
the Tools menu.
* Changes to these parameters will also be refl ected on the pump LCD.
Reload History
To reload existing pump history, select Reload History from the Tools menu.
Print Pump History
To print the pump history fi le displayed on screen, select Print from the File menu
(see page 31).
Save Pump History
To save a pump history to a PC, select Save from the File menu. The pump history
is saved to a PC as a history fi le (.hst).
Save Pump History as Comma-separated Text
To save a history fi le as a text fi le (.txt), select Save as Comma-separated Text from
the File menu.
Pump History Display
Data displayed in the Pump History window (Figure 38) shows the record or history
of all operations performed by the pump. A history will remain on screen and in
pump memory until it is cleared. If more than 300 history operations have occurred
since history was cleared, they will roll over in memory so that the 300 most recent
operations will be displayed. A history includes the following data:
Pump Status Mode
Readout Operating State of the Pump
Run ........................pump in run mode
Hold ......................pump in hold mode
Fault (Run) ...........pump in fl ow fault status while running
Fault (Hold) ..........pump in fl ow fault status and hold mode
Prog (Hold) ..........pump in hold mode while running a program
Prog (Run) ............pump in fl ow mode while running a program
Prog (Sleep) ..........pump in sleep mode while running a program
Reset ......................run time data has been zeroed
Sleep ......................pump in sleep mode