SKC DataTrac for the Leland Legacy - Manual (Page 15)

12
SKC Real Time Monitor
Temperature Display
The Temperature Display (Figure 11) shows the temperature of the air entering the
connected pump.
Cell Readout
Min ........................................................minimum air temperature during the
program run
Max........................................................maximum air temperature during the
program run
TWA ......................................................time-weighted average (TWA) of all air
temperatures
Ambient ...............................................current air temperature
Note: The Temperature Display is not ambient
air temperature. It refl ects the temperature of
the air within the pump.
The Min, Max, and TWA are calculated from
the temperatures measured during the total run
time of the pump. Unless reset, the temperature
data will remain in memory and will be included
in future Min, Max, and TWA calculations.
Reset by clicking on the Reset Volume, Temp,
Run Time, and Pressure butt on in the Pump
Controls section of the Real Time Monitor
(Figure 11A).
Figure 11. Temperature Display
Figure 11A. Reset Volume,
Temp, Run Time, and
Pressure Button