SKC DataTrac for the Leland Legacy - Manual (Page 17)

14
SKC Real Time Monitor
Figure 14. Units Selection Buttons
Figure 15. Fault Options
Units Selection Buttons
The Units Selection butt ons (Figure 14) allow the user to select the temperature and
pressure units of the connected pump.
Control Function
Fahrenheit ....................................selects the Fahrenheit temperature scale
Celsius ..........................................selects the Celsius temperature scale
in-Hg .............................................selects the atmospheric pressure display in units of
inches of mercury
millibar .........................................selects the atmospheric pressure display in units of
millibar
mm-Hg..........................................selects the atmospheric pressure display in units of
millimeters of mercury
Fault Options
The Fault Options (Figure 15) allows the user to select the time the pump spends in
fl ow fault mode and the number of times the pump att empts to restart.
Cell/Control Readout/Function
Time to Fault (sec) ..................click on the box and enter a number from 5 to 30.
This value is the number of seconds the pump spends
in Flow mode before going into Flow Fault Hold
mode.
Number of Retries ..................click on the box and enter a number from 0 to 25.
This value is the number of times the pump att empts
to restart once it goes into Flow Fault Hold mode.
Time to Retry (sec) .................click on box and enter a number from 5 to 600. This
value is the number of seconds between when the
pump goes into Hold aft er a fl ow fault and when it
restarts.
Set Fault Options ....................saves the chosen options
Fault On/Fault Off ..................enables/disables Fault mode. When set to “Fault Off ,”
no fl ow fault will occur.