SKC DataTrac for the Leland Legacy - Manual (Page 16)

13
SKC Real Time Monitor
Figure 12. Pressure Display
Figure 13. Pump
Controls Buttons
Figure 11A. Reset Volume,
Temp, Run Time, and
Pressure Button
Pressure Display
The Pressure Display (Figure 12) shows the atmospheric pressure of the air entering
the connected pump.
Cell Readout
Min ........................................................minimum atmospheric pressure during the
program run
Max........................................................maximum atmospheric pressure during the
program run
TWA ......................................................time-weighted average of all atmospheric
pressure
Ambient ...............................................current atmospheric pressure
The Min, Max, and TWA are calculated from
the atmospheric pressure measured during the
total run time of the pump. Unless reset, the
pressure data will remain in memory and will
be included in future Min, Max, and TWA
calculations. Reset by clicking on the Reset
Volume, Temp, Run Time, and Pressure butt on
in the Pump Controls section of the Real Time
Monitor (Figure 11A).
Pump Controls Buttons
The Pump Controls butt ons (Figure 13) directly control the
connected pump.
Control Function
Run ...............................................places the pump in RUN
Hold ..............................................places the pump in HOLD
Set Flow .......................................opens the Monitor Set Flow
window (similar to Figure 25)
Reset Volume, Temp,
Run Time, and Pressure .....clears the accumulated data: volume, temperature
(Min, Max, and TWA), time, and pressure (Min, Max,
and TWA)