Asante Technologies 40240/40480-10G - Manual (Page 422)

* These commands only apply to the serial port.
line
This command identifies a specific line for configuration, and to process subsequent
line configuration commands.
Syntax
line {console | vty}
• console - Console terminal line.
• vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
23-17
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Table 23-7 Line Commands
Command
line
login
password
timeout login
response
exec-timeout
password-thresh
silent-time *
databits *
parity *
speed *
stopbits *
disconnect
show line
Function
Identifies a specific line for configuration and starts the line
configuration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a login attempt
Sets the interval that the command interpreter waits until user
input is detected
Sets the password intrusion threshold, which limits the number of
failed logon attempts
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
Sets the number of data bits per character that are interpreted and
generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Terminates a line connection
Displays a terminal line's parameters
Mode Page
GC 23-17
LC 23-18
LC 23-19
LC 23-20
LC 23-20
LC 23-21
LC 23-22
LC 23-22
LC 23-23
LC 23-23
LC 23-24
PE 23-24
NE, PE 23-25
Line Commands
23