Robertshaw SlimZone PREMIER ZONE CONTROL SYSTEM - Manual (Page 6)

R. All zones served by a SlimZone control module should have the same basic load characteristics
(i.e., do not put 4 zones on an east exposure, and the 5th zone on a southwest exposure).
S. All references to typical dampers refer to Enerstat model dampers.
T. Zones 14-19 adhere to the same schedule and act as a single call for equipment. Although they
are separate physical zones they act as a single zone when communicating with the SZP
Control module. It is recommended that when considering the layout of your zone system,
zones 14-19 should be assigned to areas of low priority.
3. COMPONENT REQUIREMENTS
3.1 BASIC SYSTEM
The basic system consists of the main SlimZone Premier Control module (SZP-3: 3 zone
module) and its supporting components.
ITEM QUANTITY CONSIDERATIONS
SZP-3 control module one (1) contains three (3) zones
DSL-520P zone thermostat one (1) per zone use standard nonshielded 4
conductor 18-24AWG copper wire
Motorized zone dampers one (1) per zone (minimum) use standard nonshielded 3
conductor 18AWG copper wire
24VAC transformers one (1) for main module 75VA
zone dampers powered by refer to section 3.4 for sizing
separate transformer(s)
Table 3.1: SlimZone Premier Basic Components
3.2 EXPANDER MODULE
Each SlimZone Expander module (SZEX) consists of two (2) additional zones. For each
expander module added, the following items are required:
ITEM QUANTITY CONSIDERATIONS
SZEX expander module one (1) contains two (2) zones
DSL-520P zone thermostat one (1) per zone use standard nonshielded 4
conductor 18-24AWG copper wire
Motorized zone dampers one (1) per zone (minimum) use standard nonshielded 3
conductor 18AWG copper wire
24VAC transformers SZEX powered by SZP N/A
zone dampers powered refer to section 3.4 for sizing
by separate transformer(s)
Table 3.2: SlimZone Expander Module Components
Note: Expander module itself does not require a transformer as it is powered by the control
module.
SlimZone Premier 3