Allied Telesis AT-WA1104G-10 - Manual (Page 72)

Features in 291-04 72
Version 291-10
C613-10488-00 REV G
CR00014328 IP Gateway,
Switch
3 If a port had static ARP entries defined for a VLAN, then adding the port to
another VLAN made those static ARP entries inactive.
Also, deleting a port from a VLAN would delete all static ARP entries that were
defined on that port, including entries for other VLANs. Note that this deletion
issue did not occur on Rapier i, AT-8800, AT-8700XL, or AT-8600 Series switches.
Both of these issues have been resolved.
Y – Y Y Y Y Y Y Y Y
CR00014652 PIM6 3 If a user changes the PIMv6 BSR candidate priority to the same value as the
currently-elected BSR’s priority, then the router or switch should be elected as the
BSR if its IPv6 address is higher than the currently-elected BSR. This did not
happen.
This issue has been resolved.
Y Y Y Y Y – – Y Y Y
CR00014659 DHCP 3 On the DHCP server, a user could create two static DHCP entries for the same
client in one range. This was only possible if the client had first obtained a
dynamic address from the server.
This issue has been resolved. It is now impossible to add the same static client
twice, even when that client has a pre-existing dynamic entry.
Y Y Y Y Y Y Y Y Y Y
CR00014724 IGMP
Snooping
3 When the router or switch received an IGMP Leave message, it did not update
IGMP Snooping counters correctly in some circumstances.
This issue has been resolved.
Y – Y Y Y Y Y Y Y Y
CR00014746 WANLB,
IP Gateway
3 It was possible to delete an IP interface that was configured as a WAN load
balancer resource.
This issue has been resolved.
Y Y – – – – – – – –
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800