Allied Telesis AT-WA1104G-10 - Manual (Page 31)

Features in 291-08 31
Version 291-10
C613-10488-00 REV G
CR00016452 PPP 3 It is valid to use the command create ppp=number to create a PPP
interface without specifying the underlying layer 1 interface. However,
executing this command, or including it in a boot script, resulted in an error.
This issue has been resolved.
Y Y Y Y Y Y - - Y Y Y
CR00016578 IPv6 3 If IPv6 was disabled and a user entered any of the following commands:
add ipv6 interface
add ipv6 6to4
add ipv6 tunnel
create ipv6 interface
enable ipv6 advertising
then the router or switch correctly displayed a warning message to indicate
that IPv6 was disabled and also correctly performed the specified
configuration. However, it did not display an “Operation successful”
message to indicate that the configuration had changed.
This issue has been resolved. The router or switch now displays the
“Operation successful” message as well as the warning message.
Y Y Y Y Y Y - - Y Y Y
CR00016735 ATM 3 Sometimes, the router displayed the following error message:
Internal Error: speed mismatch causing transmit internal rate underrun
error.
This was due to a mismatch in the synchronisation between the internal
rate of the ATM controller in the CPU and the speed of the ATM PHY
connector. This synchronisation mismatch had a small impact on ATM
performance.
This issue has been resolved.
Y - - - - - - - - - -
CR00016925 TTY 3 If a user was accessing the router or switch via telnet, and sent a ^P (break)
character followed by the character d or D, then the router or switch
displayed an unwanted diagnostic message.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y Y
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
Rap
ier w
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800